Installation Instructions - CornerTRIM™

1. Take the TrimCLIPs™ provided in this package and press them into the slots on the back of the CornerTRIM. Insert the end leg first and then flex or bow the clip to align the second leg with the slot and snap down into place---lightly tap with a hammer if necessary.
2. Beginning at the top of the wall put the CornerTRIM™ in place being sure that it is plumb and level, be certain that the top TrimCLIPS are at the very top of the slot provided to eliminate slippage of the CornerTRIM, nail the top clip to the sidewall, proceed to fasten the CornerTRIM by nailing through the remaining TrimCLIPs with the nails provided.
3. If additional sections of CornerTRIM are needed to complete the corner, it is recommended that an ATW #20 plastic biscuit at the butt joint be used to assure proper alignment. Prepare the ends of both sections of CornerTRIM to receive the biscuit, insert the biscuit, apply a bead of Bond & Fill™adhesive (following the directions on the package) to one section of CornerTRIM and slide the other piece into place. Again, be certain that the top clip is at the top of the slot on the back of the additional piece of CornerTRIM, continue to fasten the CornerTRIM as
   directed above.
4. Clean any dirt marks from your trim using a mild detergent or lightly sand with a fine
   grit sandpaper.
5. While your new CornerTRIM™ does not require painting, we recommend painting with a high quality 100% acrylic latex to keep the trim clean and fresh looking for years to come.